ECO-PROTECT (Eurostars-Eureka) project participated in MetalMadrid 2019

Surface Engineering

MetalMadrid is the leading annual industrial show tailored to meet the needs of today´s advanced manufacturers and suppliers.

The ECO-PROTECT poster participation took place in Madrid, Spain from 27th to 28th of November, 2019. The aim of this annual participation is dual. FINITEC ELECTROLISIS, S.L. (project coordinator) participating as exhibitor company of a wide variety of surface treatments, while in parallel was to communicate and disseminate with a poster presentation the progress of the project. Some partners, CHEMPLATE MATERIALS S.L. (Barcelona), CTME (Burgos) and CIDETEC Surface Engineering (San Sebastian) attended this event.

In addition, CIDETEC Surface Engineering also participated with an oral presentation entitled “Postprocessing a key factor for additive manufacturing” given by Jose Antonio Díez.

The ECO-PROTECT project aims to validate and improve REACH compliant alternative coatings (including the pre-treatment, also a crucial step) that can replace the currently Cr(VI) surface treatments for protection of aerospace Al alloys.

For more information:

Metal Madrid 2019: https://www.easyfairs.com/metalmadrid-2019/metalmadrid-2019/

ECO-PROTECT project:https://www.eurostars-eureka.eu/project/id/11890

New Filament Winding and ATL equipment

CIDETEC Surface Engineering Hosts Training on Composite Materials

CIDETEC Surface Engineering promotes new chemical and mixed composite recycling technologies in the COMAR project

The RESINSURF project by CIDETEC Surface Engineering will offer sustainable alternatives for the surface treatment industry

CIDETEC Surface Engineering participates in the European BioPhenom project to develop safe and sustainable materials

CIDETEC Surface Engineering advances as a Cervera Center of Excellence with the start of the SURFERA-PLUS project

CIDETEC Surface Engineering and Hyundai Motor Company / KIA join forces

CIDETEC Surface Engineering embarks on the BioStruct project, which will promote the use of biocomposite materials in the maritime and wind industry

CIDETEC Surface Engineering has installed the demonstrator to give the next step in the CUIDETEC project

CIDETEC will host the ‘Surface Treatments Pilot Lines workshop’

CIDETEC Surface Engineering develops a type of epoxy to build lighter and more sustainable trains

The INTEGRIA project will extend the lifetime of floating wind farms through Artificial Intelligence (AI)

Hydrogen containers and 100% recyclable car seats, goals of the CUBIC project

CIDETEC Surface Engineering bolsters its equipment with a new RF-GDOES device